Sunsong 2201929 Brake Hydraulic Hose

The Sunsong 2201929 brake hydraulic hose is built for direct replacement on select Ford Super Duty rear brake applications. It is engineered to match the original fit and restore proper hydraulic performance for the rear right outer or rear right position, depending on vehicle configuration.

• Direct-fit brake hose for select Ford F-250 Super Duty and Ford F-350 Super Duty applications
• Banjo end fitting on one side and female fitting on the other
• EPDM hose material for brake system use
• 10.23 in. overall length, 260 mm
• Precision-engineered to restore original routing and fitment
• Built to meet or exceed DOT, FMVSS 106, and SAE J1401 standards
• Includes new copper washers for banjo-end sealing

Fitment Details

Compatible With 2011-2016 Ford F-350 Super Duty, rear right outer, w/ SRW, w/ Narrow Frame. Compatible With 2015 Ford F-250 Super Duty, rear right, w/ Narrow Frame. Compatible With 2013 Ford F-250 Super Duty, rear right, w/ Narrow Frame. Compatible With 2010 Ford F-350 Super Duty, rear right outer, From 2/22, w/ SRW, w/ Narrow Frame.

This part cross-references Raybestos Brakes BH382771 for the same application.

Product Description

Designed as a replacement brake hose for Ford F-250 Super Duty and Ford F-350 Super Duty rear brake service, Sunsong 2201929 helps restore hydraulic connection between the hard line and caliper area. The hose uses an EPDM construction and the specified banjo and female end fittings to match the original routing on listed vehicles. Sunsong 2201929 is also manufactured with corrosion-resistant steel tubing and zinc electroplating on applicable tubing components to help resist rust from moisture, road salt, and grime.

What This Hose Helps Address

• Cracked, swollen, or leaking brake hose sections
• Brake fluid seepage at the rear right hose connection
• Restricted brake fluid flow caused by aged hose material
• Corrosion at exposed tubing or fitting areas
• Loss of proper rear brake pedal response on listed Ford Super Duty trucks

Installation Notes

Verify the vehicles rear brake position, frame configuration, and single rear wheel setup before ordering. Match the banjo and female fitting types, along with the 10.23 in. length, to the original hose being replaced. For banjo-end installations, use the included copper washers to help achieve proper sealing. After installation, inspect the system for leaks and confirm secure routing away from moving or heat-exposed components.

Quality Assurance

Each hose is pressure tested before it leaves the factory to help confirm proper operation. This brake hose is manufactured to meet or exceed DOT, FMVSS 106, and SAE J1401 requirements.