Wheel Bearing and Hub Assembly Overview

The GSP New Wheel Bearing and Hub Assembly, part number 126062, is a direct-fit driveline replacement for select Dodge Ram 2500 applications. It combines the hub and bearing into one assembly for service on the front axle and is built around a Gen 3 taper bearing design.

Compatible With 2000-2001 Dodge Ram 2500, front. Part number 126062 also cross-references MOOG Hub Assemblies 515062 for the same application.

Key Features

• Wheel bearing and hub assembly for front-end service
• Gen 3 bearing generation with taper bearing construction
• 4 wheel studs and 33 inside splines
• 121 mm hub pilot diameter and 205 mm flange diameter
• Bolts included for installation
• ABS not equipped application

Detailed Description

GSP 126062 is engineered as a wheel bearing and hub assembly for the front position on select Dodge Ram 2500 trucks. The assembly uses a taper bearing design and Gen 3 bearing construction, with a 121 mm hub pilot diameter, 54.3 mm flange offset, and 205 mm flange diameter. It also features a 165 mm bolt circle, 4 wheel studs, and 33 inside splines to match the specified driveline setup. Part number 126062 is a practical replacement when the original hub assembly shows wear, looseness, or mounting issues.

What It Is Used For

• Wheel bearing noise from a worn hub assembly
• Excessive play or looseness at the wheel end
• Hub mounting or spline engagement problems
• Front-end service on a Dodge Ram 2500

Installation Notes and Tips

Verify the 2000-2001 Dodge Ram 2500 front application before ordering. Confirm hub pilot diameter, bolt circle diameter, inside spline count, and stud count against the original part. This assembly includes bolts, and the vehicle is listed without ABS for this application.

Quality Assurance

GSP supplies replacement driveline and hub components for service applications. Use part number 126062 to match the specified fitment and dimensional requirements for the correct installation.