Delphi rear right stabilizer bar link

Delphi TC6937 is a rear right suspension stabilizer bar link built with steel housing and bushing ends for direct replacement service. It is engineered for Mercedes-Benz S-Class applications and uses OE-focused dimensional and material analysis to support proper fit.

Key features

• Steel housing for durable suspension service.
• Bushing ends with bushings included for the link assembly.
• Locking nuts included for secure fastening.
• Grease-free design with no dust boot, washers, or bolts included.
• OE-focused engineering from Delphi aftermarket steering and suspension expertise.

Detailed description

This Delphi stabilizer bar link, part number TC6937, is a rear right suspension component for Mercedes-Benz S450, S560, S63 AMG, S65 AMG, S550, S550e, and S600 models in the fitment range shown. It is built to match OE dimensions and material characteristics, helping maintain consistent sway bar connection geometry in the rear suspension. Delphi TC6937 is a practical choice when replacing a worn stabilizer link on a Mercedes-Benz S-Class platform.

Delphi applies OE safety technology and extensive testing to its aftermarket steering portfolio. This part is exposed to extreme temperature cycling and salt-spray testing, and the brand uses dimensional and material analysis to improve compatibility between OE and replacement parts. This part cross-references Mercedes-Benz 222 320 04 89 and A 222 320 04 89 for the same application.

What it is used for

• Clunking or rattling from the rear suspension.
• Excessive play in the sway bar connection.
• Uneven handling response during cornering.
• Wear-related looseness at the stabilizer link mounting points.
• Replacement of a damaged rear right stabilizer bar link.

Installation notes and tips

Verify rear right fitment against the vehicle application before installation. Confirm the bushing-end configuration and mounting dimensions match the removed part, especially on Mercedes-Benz S-Class models. Inspect adjacent suspension hardware and mounting points for wear before completing the repair.

Quality assurance

Delphi backs this part with OE-focused engineering, temperature testing below -40 degrees C and above 120 degrees C, plus 720 hours of salt-spray exposure testing to evaluate durability and corrosion resistance.